Jet JWBS-20 Operating Instructions Manual

Also see for JWBS-15: Operating instructions and parts manual Operating instructions

Contents

Jet JWBS-20 Operating Instructions Manual Manual pdf 19 page image

Fig 52JET part number: JWBS15-1125The table insert may not project above table surface.Saw blades:The servicing of sawblades should only be performed by atrained person.Only use sharp and properly set sawblades.Lubrication points:Periodically apply a light all-purpose grease to rack and pinion(Fig 53).Fig 53To the table trunnions (Fig 54).Fig 54To the blade tension screw (Fig 55).Fig 55Note:Bearings on the band saw are pre lubricated and sealed anddo not require attention.9. Trouble shootingMotor doesn’t start*No electricity-check mains and fuse.*Defective switch, motor or cord-consult an electrician.*Overload has reacted-Wait and start again.*Wheel covers not closed-Machine vibrates excessively*Stand on uneven floor-adjust stand for even support.*dust on wheel-clean tires.*sawblade has cracks-replace sawblade immediatelyCut is not square*Table stop setting wrong.*Blade guide setting is badCutting surfaces is bad*Wrong sawblade used*resin collection on sawblade*sawblade is dull*Blade guide setting is bad*Blade tension too low*workpiece inhomogeneous*Feed pressure too high-Do not force the workpiece.10. Environmental protectionProtect the environment.Your appliance contains valuable materials which can berecovered or recycled. Please leave it at a specializedinstitution.