Jet JWS-25CS Owner's Manual

Also see for JWS-25CS: Specifications

Contents

Jet JWS-25CS Owner's Manual Manual pdf 11 page image

11Table Ring Removal and InstallationDisconnect the machine from power source,unplug!The rings should easily lift out of the tableinsert. The table insert has three setscrews thatcan raise and lower the insert. The insertshould be slightly lower than the table. Keepthe rings and insert clean to prevent them fromsticking. If the rings are difficult to remove fromthe insert:1. Remove any collet or spindle assembly inthe spindle.2. Lower the spindle assembly.3. Place a scrap of piece of wood between thering to be removed and the spindle.4. Raise the spindle until the ring lifts out.5. Clean rings and insert thoroughly.OperationSpindle ControlTo raise or lower spindle:1. Loosen spindle lock handwheel found onthe left side of the cabinet.2. Raise or lower spindle to desired height byturning handwheel found on the front sideof the cabinet. There is an indicator scalefound by the handwheel, which will aid withraising and lowering measurements.3. Tighten spindle lock handwheel.Using the Fence as a GuideShaping with the fence is the safest and mostsatisfactory method of working. This methodshould always be used when work permits.Almost all-straight work can be used with thefence.1. For most work, where a portion of the edgeof the work is not touched by the cutter,both the front and rear fences are in astraight line, as shown in figure 8.