Jet JWS-25CS Owner's Manual

Also see for JWS-25CS: Specifications

Contents

Jet JWS-25CS Owner's Manual Manual pdf 14 page image

14TroubleshootingProblem Possible Causes and Solutions:Shaper will not start *Fuse blown or circuit breaker trippedReplace fuse or reset circuit breaker*Cord damagedReplace cord*Cord unplugged from the power sourcePlug in power cord*Reversing switch is in the OFF positionTurn switch to forward or reverseOverload kicks out frequently *Extension cord or wiring inadequate sizeReplace cord or wiring with proper gauge wiring*Feeding stock too fastReduce stock feed rate*Cutter head is dullUse only sharp cuttersCutter does not come up to full speed *Shop wire gauge is too smallReplace cord or wiring with proper gauge wire*Extension cord too light or too longReplace with adequate size cord*Power source is not adequateContact local electrical utilityCuts are unsatisfactory *Dull cutterReplace cutter*Gum or pitch on cutterRemove cutter and clean with solvent*Cutterhead rotating in the wrong directionCheck for proper rotation at start up*Feeding work in the wrong directionFeed work against the cutter rotationMachine vibrates *Cutterhead damagedReplace cutterhead*Stand on uneven surfaceStand must rest solidly on level surface, bolt to floorif necessary*Defective V-beltReplace V-belt*V-belt incorrectly tensionedApply proper tension*Bent pulleyReplace pulley*Motor mounted improperlyMotor must be properly mounted with snug nuts andbolts