Jet JWS-25CS Owner's Manual

Also see for JWS-25CS: Specifications

Contents

Jet JWS-25CS Owner's Manual Manual pdf 7 page image

7Assembly1. Attach table extension wing to the shapertable using three hex cap bolts and threewashers.2. Attach the rear door to the shaper cabinetusing two pins.3. Attach the chrome handle to the raising andlowering handwheel located on the front ofthe machine.4. Attach the plastic handle to the motorbracket plate.5. Place the dust chute (A, Fig. 1) on the tableand secure by threading two ratchetinghandles (B, Fig. 1) into the tabletop.6. Secure the spindle guard assembly to thedust chute using two knobs and two washers(C, Fig. 1). Note: You should first attachthe wood piece to the two brackets with fourwood screws. Then attach the wood andbrackets to the plate guard using two screwsand washers.7. Place the fence bracket assembly (A, Fig. 2)on the table and secure by threadingratcheting handle (B, Fig. 2) into dust chute.8. Tighten hex cap bolt (C, Fig. 2) into the dustchute using a 14mm wrench.9. Attach the wooden fence (D, Fig. 2) to thefence bracket assembly using twocountersink flat head screws (E, Fig. 2), twolarge flat washer, two lock washers and twohex nuts.10. Feed the guide support (F, Fig. 2) into thefence assembly and secure with a hex capscrew (G, Fig. 2).11. Slide the two brackets (H, Fig. 2) onto theguide supports. Place the guide plates (I,Fig. 2) between the brackets and thesupports. Tighten knob and hex cap bolt tosecure the guide plate in place. Note:Repeat for opposite side fence