English 31Figure 1 - Pos. 9 Take out sieve. Clean in water and reinstall.Figure 8 Loosen covering nut and take off hose.Figure 9 Take out sieve.NoteIf necessary turn in screw M8 appr. 5 mm in-wards and therewith pull out sieve. Clean sieve in water. Push sieve inwards. Put on hose. Tighten covering nut firmly.Figure 10 Take out detergent suck hose. Clean filter in water and reinstall.Figure 11 Ready a catch bin for appr. 1 Liter oil. ready catch gutter. loosen release screw.Kärcher Hint: Use a sliced RM 110 bottle asa catch gutter. Release oil over the catch gutter into thecatch bin. Tighten release screw. Fill oil slowly up to the MAX marking.NoteAir pockets must be able to leak out.For oil type refer to technical specificati-ons.Figure 2 - Pos. 2– Fuel tank empty Refill.Figure 2 - Pos. 4– Engine overload/overheat Turn device switch on "0" and let enginecool off for min. 5 minutes. If malfunction still occurs, have devicechecked by customer service.Figure 2 - Pos. 3– Liquid softener tank is empty, due totechnical reasons a remainder stays inthe tank. Refill.– Electrodes in the tank are dirty Clean the electrodes.Figure 2 - Pos. 5– Detergent tank is empty. Refill.Maintenance WorksClean the sieve in the water connec-tionClean sieve in the water shortagesafe guardClean filter at the detergent suckhoseOil changeDispose of old oil ecologically or turn inat a gathering point.FaultsIndicator lamp fuel shortage glowsHDS 558.../698.../798...onlyIndicator lamp "Ready for use"turns offIndicator lamp liquid softener glowsHDS 558.../698.../798...onlyIndicator light Chemistry glowsHDS 558.../698.../798...only