English 15 CAUTIONDisconnect the machine from the powersource before making any repair.TroubleshootingSymptom Cause SolutionMotor will not start On/Off switch is in the ìOFFî(O) position.Turn switch to the ìONî (I)positionPower cord is not plugged in. Plug in power cord.Electrical outlet does notsupply adequate power.Try a different outlet.Tripped circuit breaker. Switch off pressure washer.GFCI will reset once the tem-perature of the unit drops.Unit does not reachhigh pressure.Diameter of garden hose istoo small.Replace with a 5/8 inch orlarger garden hose.Water supply is restricted. Check garden hose forkinks, leaks and blockage.Not enough inlet water supp-ly.Open water source full force.Water inlet filter is clogged. Remove filter and rinse outin warm water.Spray wand is on low pres-sure position.Turn spray wand to highpressure position.Output pressure va-ries high and low.Not enough inlet water supp-ly.Turn water on full force.Check garden hose forkinks, leaks or blockage.Pump is sucking air. Check that hoses and fittingsare air tight. Turn off machi-ne and purge pump bysqueezing trigger gun until asteady flow of water emer-ges through the nozzle.Water inlet filter is clogged. Remove filter and rinse outin warm water.Discharge nozzle is obstruc-ted.Blow out or remove debriswith a fine needle.Calcified gun, hose or spraywand.Run distilled vinegar throughdetergent suction tube.