Kärcher K 5.650 Operating Instructions Manual

Contents

operating instructions

8 EnglishMount loose parts delivered with applianceprior to start-up. IllustrationPush the wheels into the intake and se-cure with the enclosed plugs, watch forpositioning of plug. IllustrationPlace the bottom holder into the recessesand push forward until it audibly locks in.Insert the top holder and push down allthe way. IllustrationPress in the storage hook and lock it intothe top position.You will need the 2 included screws as well asa Philips screwdriver PH 2. IllustrationSlide the transport handle into the guideand secure it with 2 screws.You will need the 2 included screws as well asa Philips screwdriver PH 2. IllustrationInsert both detergent hoses onto the hosefittings.Install the dosage regulator and connectusing 2 screws.Note: During installation you must makesure that the tongues of the dosage regu-lator match up with the intended recessesin the casing. IllustrationSlide the free end of the coiled high pres-sure hose through the recesses on thedosage regulator.Insert the hose drum into the intakes onthe transport handle.Insert the axle of the hand crank into theguides.Install the fixating plate and secure it us-ing 2 screws.Press the connecting fitting from the shorthigh pressure hose into the brass intake,secure with clamps.Note: Make sure the connection nipple isaligned correctly. IllustrationPush the high pressure hose into the trig-ger gun until it locks audibly.Note: Make sure the connection nipple isaligned correctly.Check the secure connection by pullingon the high pressure hose. WarningAccording to the applicable regula-tions, the appliance must never beused on the drinking water supplywithout a system separator. Use asuitable system separator manufactured byKÄRCHER; or, as an alternative, a systemseparator as per EN 12729 Type BA. Waterflowing through a system separator is consid-ered non-drinkable.CautionAlways connect the system separator to thewater supply, never directly to the appliance!Note: Impurities in the water can damage thehigh-pressure pump and accessories. Forprotection, the use of the KÄRCHER water fil-ter (optional accessory, order no. 4.730-059)is recommended.Observe regulations of water supplier.For connection values, see type plate/techni-cal data. Use a fibre-reinforced water hose (not in-cluded) with a standard coupling. (Mini-mum diameter 1/2 inch (13 mm),minimum length 7.5 m). IllustrationScrew the supplied coupling element tothe water connection on the appliance.Push the water supply hose onto the cou-pling unit, then connect it to the water supply.Before StartupInstall wheelsInstall the storage for hand-spray gunInstall the storage hook for the mains con-nection cableInstall the transport handleInstall the dosage regulator for detergentInstall the high pressure hose drumConnect the high pressure hose to thehand spray gunWater supplyWater supply from mains