– 7 STEP 2: Press ’’TEST’’, then press’’RESET’’ to assure proper connec-tion to power.Note: The actual appearance of theGFCI may be different from this il-lustration. DANGERRisk of explosion!Do not spray flammable liquids.If the appliance is used in hazardousareas (e.g. filling stations) the corre-sponding safety regulations must beobserved.Risk of injury! Hold the hand spray gunand the spray pipe firmly with bothhands.Risk of injury! The trigger and safety le-ver may not be locked during the oper-ation.Risk of injury! Contact Customer Ser-vice if the safety lever is damaged.Risk of injury from high-pressure waterjet. Slide the safety catch on the triggergun forward before performing anywork with the appliance. CAUTIONRisk of injury. Do not operate the appli-ance variant with a carrying belt whilecarrying it.Environmental damage. Clean motorsat places with a corresponding oil sep-arator only. To open the trigger gun: Actuate thesafety lever and trigger. To close the hand spray gun: Re-lease the safety lever and trigger.The appliance can be operated in thehorizontal or upright position.Note:The appliance is equipped with a pres-sure switch. The motor starts up onlywhen the trigger gun is open. Set the appliance switch to "I". Release the trigger gun. To do so,push the safety catch towards theback. Open the hand spray gun. Close the hand spray gun.The appliance switches off. Secure the trigger gun. To do so,push the safety catch towards thefront.After the interruption: Release the trigger gun. To do so,push the safety catch towards theback. Open the hand spray gun.The appliance will switch on again. Shut off water supply. Open the hand spray gun. Switch on the pump with the powerswitch and allow to run for about 5-10 seconds. Close the hand spray gun. Set the appliance switch to "0/OFF“. Pull main plug out of socket with dryhands only. Remove water connection.OperationOpening/closing the trigger gunOperationInterrupting operationTurn off the appliance9EN