KEB COMBIVERT F5 Installation Manual

Also see for COMBIVERT F5: INSTALLATION GUIDELINE Instruction manual Instruction manual Installation manual Installation manual

GB - 49This manual describes the KEB COMBIVERT F5. Particular attention is paid to the installation,the connection as well as the basic operation. Due to the various application and programmingpossibilities, the application-specific connection and/or wiring diagram, the parameter adjustmentas well as instructions to the start-up are to be taken from the documentation of the machinemanufacturer.A list of instruction manuals and documents giving assistance for the construction, documentationand service is provided at the end of this manual. The safety and warning notes listed in this in-struction manual as well as in other documentation must be observed at any rate to ensure a safeoperation. Non-observance of the safety instructions leads to the loss of any liability claims. Thesafety and warning instructions specified in this manual do not lay claim on completeness. KEBreserves the right to change/adapt specifications and technical data without prior notice. The usedpictograms have following significance:DangerWarningCautionIs used, if life or health of the user are endangered or substantialdamage to property can occur.Attentionobserve atall costsIs used, if a measure is necessary for safe and trouble-free ope-ration.InformationAideTipIs used, if a measure simplifies the handling or operation of theunit.The information contained in the technical documentation, as well as any user-specific advice inspoken and written and through tests, are made to best of our knowledge and information aboutthe application. However, they are considered for information only without responsibility. This alsoapplies to any violation of industrial property rights of a third-party.Inspection of our units in view of their suitability for the intended use must be done generally by theuser. Inspections are particulary necessary, if changes are executed, which serve for the furtherdevelopment or adaption of our products to the applications (hardware, software or downloadlists). Inspections must be repeated completely, even if only parts of hardware, software or down-load lists are modified. Original spare parts and authorized accessories by the manufacturer serveas security. The use of other parts excludes liability for the damages which can result from it.Application and use of our units in the target products is outside of our control and therefore exclu-sively in the area of responsibility of the user. Repairs may only be carried out by the manufactureror an authorised repair agency. Unauthorised opening and tampering may lead to bodily injury andproperty damage and may entail the loss of warranty rights.