KEB COMBIVERT F5 Instructions For Use Manual

Also see for COMBIVERT F5: INSTALLATION GUIDELINE Installation manual Instruction manual Instruction manual Installation manual

Contents

4.2.2 Set-addressing with subindexThe PROFINET subindex is used for set-addressing for all KEB parameters. A param-eter that contains more than one value is called set-programmable at KEB. These pa-rameters have always eight different values. The 1st value is addressed via set 0 andthe last value via set 7.The conversion from PROFINET-subindex to set selection can be adjusted with param-eter FBS Config. Bit6 from software version 2.9.Subindex Description for FBS config. Bit6 = 0 (subindex bit-coded)0 Indirect set-addressing: The addressed set is determined by the appro-priate set indicator. Parameter Fr.09 is valid for parameters of the driveconverter control.The operator does not have a set pointer parameter,an access with subindex = 0 corresponds here to access with subindex= 11 Direct set-addressing of set 02 Direct set-addressing of set 14 Direct set-addressing of set 28 Direct set-addressing of set 316/10h Direct set-addressing of set 432/20h Direct set-addressing of set 564/40h Direct set-addressing of set 6128/80h Direct set-addressing of set 7By this bit coding it is generally possible to address several sets with one command.However this should not be used during a read access, since an error code is returnedif not all values in the addressed sets are the same. This multiple set-addressing can beused without problems for writing of set-programmable parameters.Subindex Description for FBS config. Bit6 = 1 (subindex linear)0 Indirect set-addressing: The addressed set is determined by the appro-priate set indicator. Parameter Fr.09 is valid for parameters of the driveconverter control.1 Direct set-addressing of set 02 Direct set-addressing of set 13 Direct set-addressing of set 24 Direct set-addressing of set 35 Direct set-addressing of set 46 Direct set-addressing of set 57 Direct set-addressing of set 68 Direct set-addressing of set 7This coding of the PROFINET subindex is compatible to the coding of the new PROF-INET-PD mapping parameters (see description of parameter Fb28).20PROFINET AcycLIc DATA (PARAMETER cHANNEL) AccORDING TO PROFIDRIVE