KEB COMBIVERT F5 SERVO Installation Manualline

Also see for COMBIVERT F5 Servo: Applications manual Applications manual Installation manual

Contents

KEB COMBIVERT F5 SERVO Installation Manualline Manual pdf 17 page image

17Operation of the Unit4.1.4 Remote control (HSP5-extension)The HSP5-extension is connected between the COMBIVERT and the operator. It servesfor the remote control of the COMBIVERT. The HSP5-extension is equipped with specialcable drivers. Therefore the use of conventional RS232-cables is not permitted. The lastthree digits of the part number indicate the length of the cable in dm (00.F5.0C0-1005, -1010, -1030 and 1100).4.1.5 Other operatorsIn addition to the described operators the KEB COMBIVERT can be equipped with furtheroperators for special applications (Profibus, Interbus, Sercos, CAN, DeviceNet). You findfurther information on that on our home page.4.2 Keyboard Operation4.2.1 Parameter numbers and valuesWhen switching on KEB COMBIVERT F5 the value of parameter CP.1 appears.Principally during a change, parameter values are immediately accepted and stored non-volatile. However, with some parameters it is not useful that the adjusted value is acceptedimmediately. In these cases the adjusted value is accepted and stored non-volatile bypressing ENTER. When this type of parameter is changed a point appears behind the lastdigit.The function key (FUNC) changesbetween the parameter value andparameter number.With UP and DOWN the value of theparameter number is increased/decreased with changeable parameters.By pressing „ENTER“ the adjusted valueis accepted and non-volatile stored.235237RS232-cable 3mPC / OperatorPart number 00.58.025-001D9pole SUB-D femalePC F5-OperatorHousing (PE)FUNC.SPEEDSTARTSTOP STOPSTARTENTERF/R