14 KXS/KXG-TM-BA_IA-e-17226 Unpacking and placing6.1 Installation Site, Location of UseThe display units are designed in a way that reliable weighing results are achieved incommon conditions of use.Precise and fast work is achieved by selecting the right place for your display unitand your weighing plate.On the installation site observe the following:• Place the weighing system on a firm, level surface;• Avoid extreme heat as well as temperature fluctuation caused by installingnext to a radiator or in the direct sunlight;• Protect the display unit and the weighing plate against direct draft from openwindows or doors.• Avoid jarring during weighing;• Protect the display unit and the weighing plate against high humidity, vapoursand dust.• Do not expose the display unit to extreme dampness for longer periods oftime. Non-permitted condensation (condensation of air humidity on theappliance) may occur if a cold appliance is taken to a considerably warmerenvironment. In this case, acclimatize the disconnected appliance for ca. 2hours at room temperature.• Avoid static charge of goods to be weighed or weighing container.Major display deviations (incorrect weighing results) may be experienced shouldelectromagnetic fields (e.g. due to mobile phones or radio equipment), staticelectricity accumulations or instable power supply occur.Change location or removesource of interference.6.2 Unpacking and placingTake the display unit carefully out of its packaging, remove the plastic jacket andinstall it at the designated work space. Mount the display unit in a way that facilitatesoperation and where it is easy to see.6.3 Scope of delivery / serial accessories:• For display unit, see chapter 2• Plug for connection to load cell• Operating manual
