67 PBS/PBJ-BA-e-131416.11 Animal weighing(only possible with non verifiable setting)This function is used for weighing animals. The animal symbol is displayed whenthe animal weighing mode is active.Select the menu element 53 in the menu overview.• Place the weighing container on the scale pan and press the TARE /button.Note:When the weighing container is placed on the scale pan, data output is possible. It isnot a fault. This no malfunction.• Place an animal on the scale pan. Its weight must exceed 50 times the zerorange.• The value will be given automatically when the weighing value is stabilised.• Press the TARE /button or remove an animal from the scale pan.• If the displayed value is stable, but it lies below 10 times of the zero range,the balance will be zeroed automatically. Any remaining materials on thescale pan (excrement or skin) will be automatically written off and zeroed. Ifthe balance is not zeroed, the zero range value must be increased (refer tochapter 10.7).Notes:• The stand-by mode is not provided for the animal weighing function.• Press the ESCON/OFFbutton to switch over to the mains supply stand-by mode.• When live animals are weighed in the animal weighing mode, automaticextension of stability detection band is carried out. Repeatability of measuringdata is a bit lower than in other operational modes.• If an animal being weighed cannot be controlled and the automatic printingfunction does not respond, you can press the PRINTbutton to output the displayvalue. Then remove an animal from the balance. Even if the stability symbolappears before an animal is removed from the balance, the data will not beprinted again.• The stability symbol will appear earlier due to setting the wider stabilitydetection band in the menu.• If the balance returns to the zero point too slowly, the zero range is to be setto a higher value.• The initial taring function (chapter 11.2.1) cannot be used together with theanimal weighing function.