KaVo ORTHOPANTOMOGRAPH OP 3D Service Manual

Also see for ORTHOPANTOMOGRAPH OP 3D: User and installation manual Quick guide User and installation manual User manual Installation manual

Contents

KaVo ORTHOPANTOMOGRAPH OP 3D Service Manual Manual pdf 37 page image

4 Device descriptioni2000 fusesLocation Ref Value Type Replaceablei2000 F1 FUSE slow 4A250Vac 5x20 mmCooper BussmannS506-4-RYesi2000 F2 FUSE slow 6.3A250Vac 5x20mmCooper BussmannS506-6.3-RYesi2000 F3 Resettable FusePPTC 16V, 0.25A,Itrip 0.5ACooper BussmannPTS120616V025NoReplacing the i2000 image boardTo replace the board, follow the instructions given in chapter Replacing the i2000 imagecapture board.4.5.2 i3000 Main control boardThe i3000 main control board is located on top of the upper shelf. See figure Locations ofcircuit boards.The i3000 board is the main controller of the OP 3D X-ray imaging system. The mainfeatures of i3000 board are listed below.FunctionalityThe main functions of the i3000 Main control board are:• Main control of the system• Linear and pivot motion drive and position sensing• Exposure control• Image data streaming between i2000 and MWS• Audio output• User interfaces• Remote GUI through LAN• I4000 and i2000 firmware & FPGA updates.ORTHOPANTOMOGRAPH™ OP 3D 37