KaVo ORTHOPANTOMOGRAPH OP 3D Service Manual

Also see for ORTHOPANTOMOGRAPH OP 3D: User and installation manual Quick guide User and installation manual User manual Installation manual

Contents

KaVo ORTHOPANTOMOGRAPH OP 3D Service Manual Manual pdf 59 page image

6 Maintenance7. When the exposure starts, check that all exposure warning indicators are working:• Exposure warning indicator on the GUI• Yellow exposure indicator light on the Positioning panel• Yellow exposure indicator light on the Status indicator light on top of the carriage.• Audible exposure warning signal• Remote exposure switch (if in use)• Warning light (if in use)8. When the exposure ends, check that the indicator lights go out, exposure warningsignal stops and a program end tone is played.9. Check that the taken image transfers to the imaging workstation.6.1.5 Changing the fusesMain fuses are located at the rear of the carriage, under the back panel cover. To reachthe fuses, remove the cover first.NOTICE! See chapter Fuses for details on the correct fuses.To release a fuse cap, push it inwards and rotate counterclockwise with a flat headscrewdriver.Remove the fuse from the socket and replace it with a new one. Install the fuse bypushing the fuse cap in and rotating it clockwise with a screwdriver.The 10A and 15A fuses are physically of different sizes and have their own fuse caps. Ifyou need to change the fuse rating, also the fuse cap needs to be changed. The fusesare supplied with the corresponding fuse caps.6.1.6 Monitor calibrationIt is recommended to calibrate or check a test image with the primarily used workstationmonitor. Refer to the monitor/software manuals for information on how to do this.ORTHOPANTOMOGRAPH™ OP 3D 59