KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual

Also see for ORTHOPANTOMOGRAPH OP 3D: User and installation manual Service manual Quick guide User manual Installation manual

Contents

KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual Manual pdf 116 page image

9 Installation9.5.2 Standalone ConfigurationStandalone ConfigurationIn standalone configuration, the unit is connected directly to a workstation and the unitthen reserves the whole network interface card. The unit and the workstation functionas a single standalone system with no access to other networks. If it is necessary to beconnected to another network or to a server, the workstation will require two networkinterface cards.In standalone configuration, both the ETHERNET interface of the workstation andthe device IP address need to be set to have IP addresses from the same subnet, forexample 192.168.1.1 for the PC and 192.168.1.2 for the device. The recommendedSubnet mask is 255.255.255.0.A static IP address can be configured to the device through the device driver. Seesoftware documentation for more information on how to configure the imaging softwarefor device connection required for the static IP address configuration.NOTICE! When configuring a static IP address it must be set for both the deviceand the PC. The device may have initial local host IP Address (169.xxx.xxx.xxx)but this is not static unless set. It is not recommended to use addresses from thelocal host address range (169.xxx.xxx.xxx) as static IP addresses.116 ORTHOPANTOMOGRAPH™ OP 3DD519207, 19Copyright © by Palodex Group Oy. All rights reserved.See PDM system to determine the status of this document. Printed out 2019-10-07 09:30:50ApprovedReviewed Suuronen Esa 2019-09-19 12:21Approved Lassinen Juuso 2019-10-02 14:37