13E-730/630/750/79E/RT Series Installation G uide - PK3677_T_04_16Fig. 3Fig. 5Fig. 4! Caution: If the Lever is Not Assembled withthe key in the position shown in Fig. 6 & Fig.7, the inside mechanism of the lock could bedamaged if the lever is rotated and forced.6. Right-handed Lever handle: Turn the keyaprroximately 90º to 100º clockwise so that itis in the vertical position and the countersinkis in the top position. (See Fig. 6)Left-handed lever handle: Turn the keyapproximately 90º to 100º clockwise so that it isin the vertical position and the countersink is inthe bottom position. (See Fig. 7)!The key and the countersink must be in thepositions shown in Figs 6 & 7 before placingthe lever handle on the housing or the leverand the override mechanism will not work.Fig. 6countersink in the top positionFig. 7countersink in the bottom position3. Insert the cylinder into the lever handle (see Fig.3)4. Put the cylinder plug into the lever (see Fig.4)5. Making sure that the cylinder plug does not fallout, insert the key into the cylinder. The key willbe horizontal. (See Fig. 5).3 Preparing the Lever Handle andCylinder for Installation4 Steps to attach the lever handleto the lock housing*NOTE: THE POSITION OF THE KEY IS VERY IMPORTANTTroubleshooting:If you have assembled the lever and housing withthe key in the wrong position, the key will get stuck.To remove the key, turn it so that it is in the verti-cal position and insert a small flat screwdriver (seepage 15 Fig.17) into the hole under the lever handleto push Lever Catch in (see page11 Fig.2). Removekey. If it is still stuck, turn the key 90º clockwise tothe horizontal position and push the Lever Catch inagain with the small screwdriver. Remove key.