Kaba E-730 Series Installation Manual

Contents

Kaba E-730 Series Installation Manual Manual pdf 15 page image

15E-730/630/750/79E/RT Series Installation G uide - PK3677_T_04_1613. Turn the handle clockwise (for a right-handed lock) or counter-clockwise (for aleft-handed lock)14. Release the handle slowly. It should returnfreely to its horizontal position. (Fig.11)If applicable, to reduce the lever play, using the5/64 allen key (P1), tighten the set screw (O1)while pushing the lever against the front hous-ing. Make sure the lever rotates properly aftertighting the set screw (O1).10. Remove key11. Insert a small flat screwdriver (tool T, page10) into the hole on the underside of the leverhandle and push inthe lever catch.12. Pull on the lever handle.You should not be able to remove the lever handle. If it comesoff of the housing, you did not assemble the lock correctly.Return to steps 2, 3, 4 & 5 and make sure that the lever lookslike Fig. 10 and repeat this verification process. (Step 6)! Very Important: To verify that the leverhandle has been correctly attached tothe housing:Fig. 1116. Without using the key, turn the lever handleclockwise (for Right-handed locks) or coun-ter-clockwise (for Left-handed locks). Theinside drive hub should not rotate when thehandle turns. (Fig. 12)17. With the lever handle in the horizontal posi-tion, insert the key into the cylinder andturn it clockwise until it stops. (This appliesto both Right and Left-handed locks, seeFig.13)18. Let go of the key, and again turn the leverhandle clockwise (for Right-handed locks) orcounter-clockwise (for Left-handed locks). Nowthe inside drive hub should rotate in the samedirection as the lever handle when it is turned.(Fig. 14)! *This test can only be performed whenthe lock is not affixed to the door.Fig. 13Fig. 14inside drive hub rotatesfig. 12inside drive hub does not moveFig. 10A(P1)(01)6 Verify the Attachment of the LeverHandle7 Test the Movement of the LeverHandle (without the key cylinder)6a Adjust the Lever feel8 Test the Mechanical OverrideFunction