Sat Operation27SCANWith the function SCAN, satellites can be searched for, whose transponder fre-quencies are not known. Here, the frequency range of 920 to 2150 is continuouslyscanned for the receiving signals. If the receiving signals are available, the recep-tion level is displayed on the screen as a bar diagram. Four measurement rangeswith the dynamic of each 40 dB are available for the bargraph display. The meas-urement range is automatically preselected.BargraphdisplayLevel range CommentI 30-70 dBμV Automatic range change at 70 dBμVII 50-90 dBμV Auto. range change at 50 and 90 dBμVIII 70-110 dBμV Auto. range change at 70 and 110 dBμVIV 90-130 dBμV Automatic range change at 90 dBμVThe level can be controlled with an acoustic signal. The frequency of the acousticsignal varies in proportion with the receiving signal level. The volume of the acous-tic signal can be changed.The screen shows the bargraph display, which changes inproportion with the input signal.The field SCAN lights up yellow, as soon as the softkey is pressed. The entire Satfrequency range is now scanned. By pressing the button once more, the process isstopped and the softkey display changes to “scan off.“Calling up menu LNB-CONTROLIn this menu, all LNB parameters can be set, for example, remote power feedingvoltage H/V, 22-kHz-, DiSEqC-, V-SEC signal, UFOμ DiSEqC as well as LO fre-quency.Switch-over of ANALOG digit. DVBSCalling up the menu SAT MEASUREIn this menu, all Sat receiving parameters for the reception of digital or analoguesignals can be set and the measurements can be carried out. Calls up the MPEG-Decoders for digit. DVB-S.LNBCONTROLdigit.DVBS >SATMEASUREanalog>
