Kathrein MSK 24 Operating Manual

Contents

Kathrein MSK 24 Operating Manual Manual pdf 29 page image

Sat measurement29Overview of commands in Command ByteThe MSK 24 can send commands in accordance with DiSEqC 1.0 but itcannot receive them. All commands that require DiSEqC 2.0 (to send andreceive) are shown in grey in the table.Commands shown in bold type are used preferentially for Kathreinswitching matrices.HexbyteCommand Description Number ofdata bytes00 Reset Reset DiSEqC microcontroller -01 Clr Reset Clear reset flag -02 Standby Switch off the peripheral powersupply unit-03 Power on Switch on the peripheral powersupply unit-04 Set Content Set the contention flag -05 Contend Feedback only if the contentionflag has been set-06 Clr Content Clear contention flag -07 Address Feedback only if the contentionflag has not been set-08 Move C Change address if contentionflag has been set109 Move Change address if contentionflag has not been set110 Status Read status register flags -11 Config Read configuration flags -14 Switch 0 Read switching status flags(Committed Port)-15 Switch 1 Read switching state flags(uncommitted port)-16 Switch 2 Expansion option -17 Switch 3 Expansion option -20 Set LO Call up the low local oscillatorfrequency-21 Set VR Call up vertical polarization orcircular polarization with rightrotation-22 Set Pos A Select satellite position A -23 Set S0A Select switch option A -24 Set Hi Call up the high localoscillator frequency-25 Set HL Call up vertical polarization orcircular polarization with leftrotation-26 Set Pos B Select satellite position B -27 Set S0B Select switch option B -28 Set S1A Call up matrix S1 input A (inputB inactive)-29 Set S2A Call up matrix S2 input A (input -Î