Kathrein UFD 170 Operating Manual

Also see for UFD 170: Instruction de service

Contents

Kathrein UFD 170 Operating Manual Manual pdf 8 page image

Connection and Setup8The following section is intended specifically for specialistdealers. You only need to pay attention to this section if you arecarrying out the installation yourself.The “Connection diagram” section contains a sampleconfiguration.Do not connect the unit to the mains until all installation workhas been properly carried out. Refer to the information in the“Safety instructions” section.Connecting the UnitConnect the SAT-IF input on the UFD 170 to the satellite receiving sys-tem. Use a coaxial cable with a standard F connector.If the F connector is not yet fi tted on the cable, strip the insulation fromthe cable as shown in the following illustration and carefully twist theF connector onto the end of the cable until it is securely fi tted on thecable.When fi tting the connector, make sure that no wires from the braidingare touching the inner conductor - this could result in short circuit.The quality of the reception signal depends on the connection.SAT-IF ConnectionReceiving RequirementsReceiving System PresetsMake sure that your own satellite antenna system is equipped with atleast a universal LNB for digital reception in the high-band range.The presents for the control signals have been made for standardreception systems, i.e. 14/18 V for polarity reversal and 22 kHzswitching signal for low/high band changeover on multi-feed receptionsystems.7 mm10 mmIf you will be using the UFD 170 in conjunction with a CAP 210 orCAP 310 from Kathrein, the installation instructions for the relevantCAP unit must be followed during installation.braid bent back