Kathrein UFD 520 Operating Manual

Also see for UFD 520: Mode d'emploi Mode d'emploi

Contents

Kathrein UFD 520 Operating Manual Manual pdf 42 page image

Installation menuTone BurstUnder this menu point, the 22 kHz signal can be set as follows:: Switching statuses of setting Switching statuses of setting:22-kHz Signal —> High/LowandTone Burst —> Pos. A/B:22-kHz Signal —> Pos. A/BandTone Burst —> Opt. A/B22-kHz Signal —> Pos. A/BandTone Burst —> High/LowLowHigh22-kHz22-kHzOffOnPos Tone Burst 22-kHz LowHighTone BurstTone Burst01Pos. 1Pos. 2Tone BurstTone Burst010011OffOnOffOnPos. 1Pos. 222-kHz22-kHzOffOnDiSEqCIf the receiver is connected to a DiSEqC switching matrix, you will need to set thismenu point to ON.The switching criteria and the input assignments of the DiSEqC switching matrixmust be maintained. Therefore, refer to the description of the switching matrices orcontact the installer of the receiving system.DiSEqC RepeatThe DiSEqC command must be repeated if the receiver is operated (cascaded) to-gether with a receiving system with two or more series connected DiSEqC switch-ing matrices.In this case, switch the menu point "DiSEqC repeat" to 1 or 2.Factory preset: OFFUFO miniThe input frequency of the receiver is fixed in a "user-controlled processing sys-tem". The signals from the "user-controlled processing system" are transmitted onthis frequency. The reception parameters for programme selection are transferredto the receiving system by means of a DiSEqC command and set accordingly.The relevant setting that needs to be selected depends on the type of "user- con-trolled processing system".The setting should be made according to the data provided in the installation istructions for the "user-controlled processing system".n-Remote frequencyIf you have set the UFO mini menu point to ON, you will need to set the transmis-sion frequency under this menu point.Refer to the installation instructions of the "user-controlled processing system" forthe set transmission frequency.It is therefore important that you refer to the information provided in the installationinstructions of the "user-controlled processing system".UFO microThe setting under this menu point is also designed for operation of the receiver to-gether with a processing system.Control and communication between the receiver and the Kathrein UFO micro sys-tem takes place on the return of the coaxial cable.ON must be set under the UFO micro menu point if the receiver is operated to-gether with a UFO micro receiving system.During installation, the receiving system then assigns a special address to the re-ceiver so that the control instructions that are sent from the receiver to the receiv-ing system for signal selection are also recognised by this system.42