Kathrein UFD 570/S User Manual

Also see for UFD 570: Mode d'emploi

Contents

Kathrein UFD 570/S User Manual Manual pdf 15 page image

Switching On for the First Time15Switching On for the First TimeThe first steps• Make sure that you have made all connections correctly.• Connect the receiver to the mains power supply.• Switch on the receiver by pressing the power button at the frontof the unit.The operation indicator LED on the front panel lights red, the receiveris now in standby mode.Switch on the receiver by pressing the  button on the remotecontrol.• The green LED lights and the receiver assumes reception mode.The green LED at the front of the receiver provides confirmationevery time a button is pressed on the remote control.You will see the factory preset channel on your TV screen. Aninformation bar indicating the channel provider, the time, the timersettings, the channel status and the channel title will be displayed inthe bottom section of the screen provided the corresponding data aretransmitted. The number of the channel memory appears in the LEDdisplay.The red standby indicator goes out.You can now receive the TV and radio channels preset at the factoryand select them by pressing the  buttons. Press the and  buttons to select radio channels. Press the  or button to return to TV channels.Refer to the section "Channel lists – TV/radio" for information on howto set up and save other TV and radio channels.The reception status last set always reappears when the receiveris switched on.If the message "bad or no signal" appears on the screen in addition toan on-screen display indicating the channel last received, you willneed to check the system installation and/or the receiver settings. Ifthis problem only applies to individual channel slots, the problem maybe due to an interruption in the transmission signal.Factory setting of the receiverBefore you change the basic settings of your receiver, make a note ofthe settings in the form provided at the end of this User's Guide. In thisway, you will be able to restore the original settings at any time.