Kathrein UFS 923 Operating Manual

Also see for UFS 923: Operating manual

Contents

23Connection and start-upDiSEqC™ repeat:The setting for how often the DiSEqC™ command must be repeated depends on the configuration of yourreception system. Refer to the documentation for your reception system or seek assistance from a specialistengineer.- Off DiSEqC™ command is not repeated- 1 DiSEqC™ command is repeated once- 2 DiSEqC™ command is repeated twice- 3 DiSEqC™ command is repeated three timesPositionSelect the selection field "Position". Set the "Position" here to match the configuration of your reception sys-tem. You can select "Off" or a value between "1" and "4" in single unit increments.Test transponder:Select the "Test Transponder" selection field. Here you can select a transponder for checking the signalstrength bar and signal quality bar to see whether your settings are correct.When you have completed all settings for this satellite, press the  (green) button.If you have selected more than one satellite (max. 64) for tuner 1, the receiver will automatically skip to thesettings for the second satellite. Now perform the settings for the second satellite, followed by the other sat-ellite selections, in the same way as described for the first satellite.Once all settings for all the satellites that you selected have been completed, the receiver will automaticallyskip to the settings for the second tuner (assuming that for the second tuner you selected the type of con-nection "Separate" and set the signal confi guration to "Different from tuner 1"). If this is the case, now makethe settings for the second tuner in the same way as you did for the first tuner.Once you have completed the settings for both tuners and the satellites assigned to them, the receiver willautomatically display the screen for the channel search. Continue the first installation with the "Channelsearch" section.