110Main Menu - SettingsRemote Control CodeAfter calling up the menu, you will see thefollowing on-screen display:You can use this function to allowyou to operate several receivers(e.g. four UFS 923 units) using thesame remote control. You can assigneach receiver its own remote controlcode. This pre-supposes that thereceiver has been supplied with theRC 670 remote control (e.g. UFS 923)or with the RC 660 remote control(e.g. UFS 10).You can now use the remote control for your receiver to set a new remote control code (the remote controlcode 1 is set as standard). Press the following buttons simultaneously:- + + for remote control code 1- + + for remote control code 2- + + for remote control code 3- + + for remote control code 4Now press the button. If the receiver does not close the on-screen display, the receiver and the remotecontrol have not set the same remote control code. Check your setting again.To set the remote control for whichever remote control code is required in future, proceed as follows:- + for remote control code 1- + for remote control code 2- + for remote control code 3- + for remote control code 4
