Kelsec TgForce3D User Manual
                    | |
Contents
| 
Version 2.2 TgForce3D Sensor User Guide P a g e | 19FCC Compliance StatementThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment into an outlet different from that to which the receiver is connectedFCC Statement: TgForce3D Sensor contains FCC ID WAP2005Canada Regulatory ConformityThis digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set outin the Radio Interference Regulation of the Canadian Department of Communications.“Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables auxappareils numériques de la class B prescrites dans le Règlement sur le brouillage radioélectrique édicté par leministère des Communications du Canada."Contains IC 7922A-2005 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine