Kemppi FastMig MXF65 Operating Manual

Also see for MXF 65: Operating manual Quick guide Operating instructions

Kemppi FastMig MXF65 Operating Manual Manual pdf 12 page image

ENlOading the Filler Wire and autOMatiC Feed2.7Automatic wire feed makes wire spool changes faster. When changing the wire spool, thepressure of feed rolls need not be released.Simply ensure that the groove of the feed roll matches the diameter of filler wire used. Releasethe wire end from the spool and cut off any deformed section. Be careful the wire does notspill from the spool sides.Straighten about 20cm of filler wire and ensure the tip has no sharp edges. File if necessary, asa sharp wire edge may damage the wire gun liner - particularly softer plastic liners.Present the filler wire tip to the back of the wire feed rolls and press the wire inch switch onthe wire feed panel. Feed the wire to the gun contact tip and prepare to weld.NOTE! Smaller diameter filler wires may need to be loaded manually - with the feed roll pressurearms released. This is because it is easy to over estimate the pressure required to feed these smallerfiller wires. Too high feed roll pressures can easily deform filler wires and contribute to later feedingproblems.duratOrque™ 400, 4 Wheel Wire Feed MeChanisM2.8Wire guide tubesSs, Al, Fe,Mc, Fcø 0.6 ... 1.6 mm ø 2.5/64 mm,W000762,silver, plasticø 2.5/33 mm,W000956,silver, plasticø 2.0 mm,W000624,plasticø 1.6 ... 2.4 mm ø 3.5/64 mm,W001430,silver, plasticø 3.5/33 mm,W001431,silver, plasticø 3.5 mm,W001389,plasticFe, Mc, Fc ø 0.6 ... 0.8 mm ø 1.0/67 mm,W001432,white, steelø 2.0/33 mm,W001435,orange, steelø 2.0 mm,W000624,plasticø 0.9 ... 1.6 mm ø 2.0/64 mm,W001433,orange, steelø 3.5 mm,W001389,plasticø 1.6 ... 2.4 mm ø 4.0/63 mm,W001434,blue, steelø 4.0/33 mm,W001436,blue, steelø 3.5 mm,W001391,brass24.8.2005 12:5510FastMig MXF65, 67 / © Kemppi Oy / 0920I