Kemppi MXF 63 Operating Manual

Also see for MXF 63: Quick guide Operating instructions

Kemppi MXF 63 Operating Manual Manual pdf 16 page image

EN2.16 Operation of cooling unit, fastCool 10When FastCool 10 is connected to the FastMig power source for the first time, the coolerfunction is normally active. To deselect the cooler function, follow the instructions belowdepending on the power source type in use.fastmig KmsWhen leaving the factory, cooling unit status is set 'ON'. If no cooling unit is connected, set thecooling unit status to 'OFF'. Depending on your panel type follow the instructions describedin the graphic below. Having selected the cooling state required, reset the power source byswitching off at the main on/off switch. Restart the power source and weld.sf 51/sf 54WIRE INCHwelddataVAm/min4TSETUP2T UMMAMIGMMAPANELSF 51W001318DYNAMICSARC FORCEGAS TESTGAS TESTARC FORCEDYNAMICSGAS TESTARC FORCEDYNAMICSsf 52W/sf 53W> 5 sSETUP A + D B WIRE INCHGAS TESTchch clearMINILOGSETONMEMORYPANELSAVESETquicksetupwelddataARC FORCEDYNAMICS4T2TSETUPPOWERUSELECTSYNERGICPROGRAMMMAWISE1-MIGMIGA Vm/minmmSF 52W W004269MMA PENremoteCHC WIRE INCHGAS TESTchch clearMINILOGSETONMEMORYPANELSAVESETquicksetupwelddataARC FORCEDYNAMICS4T2TSETUPPOWERUSELECTSYNERGICPROGRAMMMAWISE1-MIGMIGA Vm/minmmW004269MMA PENremoteCHSF 52Wfastmig pulseThe factory default setting for FastMig Pulse is AUTO. If a cooling unit is not connected andthe operator tries to establish gas cooled operation together with a gas cooled gun, Err 27is displayed. To establish gas cooled operation, select cooler ‘OFF’. This is done in the ‘SystemConfig Menu’ as follows: Press the Menu button on the P65 power source panel. Move themenu display arrow (via panels left-hand up-down arrow keys) to select ‘System Config Menu’and then press select button. Choose ‘Water Cooling:Auto’ and change via control knob tosetting ‘Water Cooling:OFF’, then press Back/Exit. Cooler will then be set to the ‘OFF’ state forGas cooled operation. Reset power source via on/off switch and continue welding.When selected, the operation of the cooling unit is automatic, starting when weldingcommences. When welding stops the pump will continue operation for approx. 5 min,so reducing the gun and the cooling liquid to ambient temperature. Read the operationinstructions for the FastCool 10 unit.2.17 mXf hanging kitThe MXF 63, 65 and 67 wire feed units can be hanged from a special hanging kit available asan accessory. This allows the wire feed unit to be suspended above the work area.FastMig MXF 63, 65, 6714