Kemppi MinarcMig Adaptive 150 Operation Instructions Manual

Contents

MinarcMig™ Adaptive 150© Kemppi Oy 0550 9EN3.4. FILLER WIREThe machine is delivered with the welding gun connected to +pole making itsuitable for steel solid wire welding without adjustments.3.4.1. Changing the feed roll grooveThe feed roll groove is factory set for welding filler wires of 0.8-1.0 mmdiameter. The feed roll groove must be changed if you use 0.6 mm thick fillerwire.Figure 3.3. Changing the feed roll groove1. Open the feed roll from the pressure control lever.2. Switch the machine on from the main switch.3. Press the welding gun trigger and drive the feed roll in such a position thatits locking screw is up and can be opened.4. Switch the power off from the main switch.5. Open the feed roll locking screw with a 2.0 mm Allen wrenchapproximately half a turn.6. Pull the feed roll from its shaft.7. Turn the feed roll and reinstall it to its shaft all the way to the bottommaking sure that the screw is on the shaft’s level.8. Tighten the feed roll locking screw.