Kentrox q2200 Setup Manual
Also see for q2200: User guide
                      | |
Contents
| 
9Configuration worksheetAll parameters in this worksheet should be considered a minimum configuration toenable the router to pass traffic.Ethernet LAN configurationIn most cases, you can use the default LAN IP address and subnet mask. However,you must change these settings if you are installing the router on a LAN with staticIP addresses, or where another device is already using the default Ethernet LAN IPaddress of 192.168.1.1.To change the default values, go to the Configure > Interfaces > Ethernet Ports 1-4page of the router’s graphical interface, and select Edit IP in the iplan Controls list.Enter the following information:Your configuration Default value❏ LAN IP address _____._____._____._____ 192.168.1.1❏ Subnet mask _____._____._____._____ 255.255.255.0See ”Default LAN interface configuration” on page 18 for further information.For settings related to Frame Relay installations, select Switch to Frame in the T1port Controls list and enter a unique name for the Frame Relay interface, such asFR-1. (See the Q-Series User’s Guide for naming conventions.)When you return to T1 Port 1 page, select Add DLCI in the Frame Relay Controls listto add the following information for each DLCI to be configured in the router.❏ DLCI interface name(example: DLCI-101)_________ |
Related manuals for Kentrox q2200
manualsdatabase
Your AI-powered manual search engine