Kenwood C-V351 Instruction Manual

Also see for C-V301: Service manual Service manual

Contents

Kenwood C-V351 Instruction Manual Manual pdf 9 page image

9C-V351/C-V301 (EN)ON/STANDBYPHONES INPUT TAPE 2(MONITOR)VOLUME CONTROLDOWN UPAV CONTROL CERTER KC-2CLOCKTIMERMODERDSPTYDISPLAYTIMERSETS.DIRECT TA/NEWS/INFO.STEREO DSPA.MEMO AUTO BANDTUNINGPTY SELECTMODE MULTI.CONTROLLEVELOPEN/CLOSE1 3( ¡ ™) £ ¢AUTORDSEONPTYTIMERNEWSINFO.FMLWMWTATPPRO LOGICPRO LOGIC3 STEREODSPDSPTAPE 2STEREOTUNEDMUTESLEEPdBmsMHzkHz1 2SOURCEDIRECTMEMO4 098765!@ #$ ^% & *2The keys which have the same names as the controls on theremote control unit provide the same functions as them.$ TIMER MODE keyPress to switch the timer modes.% S.DIRECT keyPress to switch the Source Direct functionwhich allows to reproduce the source witha better quality.^ RDS DISPLAY keyPress to switch the RDS display.& RDS PTY keyFor use during reception of RDS broadcast-ing.* RDS TA/NEWS/INFO. keyFor use during reception of RDS broadcasting.( A.MEMO keyPress when using the auto memory func-tion.) AUTO keyPress to select the tuning mode.The auto tuning or manual tuning mode canbe selected.The input selection display of a source canbe switched to another by pressing andholding the AUTO key for more than 2seconds. 01 (ON/STANDBY) keyPress to switch between ON and STANDBY.2 Remote sensor3 TIMER SET keyPress to set the timer function.4 CLOCK keyPress to set the clock.5 STEREO key6 DSP key7 DOLBY key8 MODE keyPress to switch various setting modes.9 MULTI.CONTROL keyPress to select various setting modes.0 GRC transmitterOutputs the signals transmitted to theGraphical Remote Control.! PHONES jackFor use in headphones listening.@ INPUT SELECTOR keyPress to select the input.# TAPE 2 (MONITOR) keyFor use in monitoring of recording, etc.¡ BAND keyPress to switch the broadcasting band.™ TUNING key ( , )Press to select the radio station to be re-ceived.These keys are also used in the clock adjust-ment and timer operations.£ OPEN/CLOSE key¢ VOLUME CONTROL knobMEMORY indicatorRDS indicators(RDS, TP, TA, EON, PTY, NEWS, INFO.)Frequency display, inputselector display, presetchannel display, surroundmode displayDecibel indicatorDelay time indicatorDSP indicatorTAPE 2indicatorAUTO tuning mode/AUTO stereoreception indicatorSTEREO indicatorTUNED indicatorMUTE indicatorSOURCE DIRECT indicatorSLEEPTIMERindicatorPRO LOGICindicator3 STEREOindicatorReceiving frequencyunit indicatorsDisplayTIMERindicatorsBroadcast bandindicatorsStandby modeWhile the standby indicator of the unit is lit, a small amount of current is flowing into the unit’s internal circuitry to back up the memory. This conditionis referred to as the standby mode of the unit. While the unit is in the standby mode, it can be turned ON from the remote control unit.With this unit, standby mode is indicated by means of the display panel. The system is in standby mode while the clock display is shown.Controls and indicators