78 EnglishInstalling the MicrophoneUnit (DDX6023BT/DDX6053BT/ DDX4023BT/DDX4053BT/DDX42BT only)1 Check the installation position of themicrophone (accessory 7).2 Remove oil and other dirt from theinstallation surface.3 Install the microphone.4 Wire the microphone cable up to the unitwith it secured at several positions usingtape or the like.⁄• Install the microphone as far as possible from themobile phone.Fix a cable with clamps (commerciallyavailable).Peel the release coated paper of double-faceadhesive tape to fix on the place shown above.Adjust the direction of the microphone to thedriver.Accessory 7Removing the Unit(DDX4023BT/DDX4053BT/DDX3023/DDX3053/DDX42BT/DDX35 only)• For removing DDX6023BT/DDX6053BT, ☞ page 73.1 Remove the trim plate by referring tothe removal procedure in the section“Removing the Trim Plate”.2 Insert the two extraction keys 4 deeplyinto the slots on each side, as shown.Accessory 43 Lower the extraction keyl toward thebottom, and pull out the unit halfwaywhile pressing towards the inside.⁄• Be careful to avoid injury from the catch pins onthe removal tool.4 Pull the unit all the way out with yourhands, being careful not to drop it.Downloaded from www.vandenborre.be