PRK SWREVERSE(ACC)(BATT)(GND)ENGLISH 55CONNECTION/INSTALLATIONCONNECTION/INSTALLATIONConnection Connecting wires to terminalsSee page 56. See page 57.*1USB terminal: Seepage 56.10 A fuseIgnition key switchFuse boxBatteryConnect to the vehicle’s reverse lamp harness whenusing the optional rear view camera.Connect to the vehicle’s parkingbrake detection switch harness.• For best safety, be sure toconnect the parking sensor.Depending on what antenna you are using, connect either to the controlterminal of the motor antenna, or to the power terminal for the boosteramplifier of the film-type antenna. (Max. 300 mA, 12 V)When using the optional power amplifier, connect to its power control terminal.To the terminal that is grounded when either the telephone rings or duringconversation. (To connect the Kenwood navigation system, consult yournavigation manual.)To use the steering wheel remote control feature, an exclusive remote adapter(not supplied) matching your car is required.To car light control switchTo car chassisPurple with white stripe(Reverse sensor wire)Light green(Parking sensor wire)Connect SiriusXM Connect Vehicle Tuner(commercially available). See page 56.*231 White ª / White with black stripe · : To front speaker (left)Gray ª / Gray with black stripe · : To front speaker (right)Green ª / Green with black stripe · : To rear speaker (left)Purple ª / Purple with black stripe · : To rear speaker (right)Blue (Antenna control wire)Blue with white stripe (Power control wire)Brown (Mute control wire)Light blue with yellow stripe (Steering remote control wire)Orange with white stripe (Dimmer control wire)Red (Ignition wire)Yellow (Battery wire)Black (Ground wire)*1 Only for DDX771/DDX491HD/DDX471HD/DDX371/DDX310BT/DDX3071BT.* 2 Only for DDX771/DDX491HD/DDX471HD/DDX371/DDX310BT/DDX271.* 3 If no connections are made, do not let the cable come out from thetab.Connect the antennacord to the antennaterminal.See page 57.*3