72 DNX series DNX7360BT/ DNX7360BTMSetup MenuEXT SW SetupEXT SW SetupSets up the exteral switch power mode.1 Display the EXT SW screenTouch [ ] >> [ ] >> [System] >>[EXT SW]. (page 67)2 Perform EXT SW Setup[SW1 Name]/ [SW2 Name] Sets thename of the external device. See To Use the Character Entry Screen>(page 72) for information on how to entera name.[Output Pattern] Sets the power signaloutput mode.( EXT SW1: Pulse, EXT SW2: Level)"Pulse": Generates a single power signalpulse."Level": Continues output of highpower signal.Sets to turn output on/off each time thebutton on the EXT SW Control screen istouched. See Supply Control> (page 47).[Pulse Set] Sets the Pulse signal outputtime.Outputs 500ms when "1" is set.Increases by 200ms with each step. Upto 100 steps can be set.How To Use the Character Entry Screen1111 Enters characters.[2], [3] Shifts the cursor.[5], [∞] Scrolls up or down thecharacter button display.[Shift] Toggles between uppercase andlowercase.[qwe]/ [abc] Sets the key layout of thecharacter buttons.abc : Alphabetical key layout.qwe : Qwerty key layout.[Clear] Clears the character.If you erase a character, locate thecursor on it and touch this button.[Space] Enters a space.⁄• You can enter characters only after you haveapplied the parking brake.
