Kenwood DDX8901HD Instruction Manual

CONNECTION/INSTALLATIONConnectionR Connecting wires to terminals(ACC)(BATT)(GND)62Page 64 Pages 63 – 64Page 65USB terminal:Pages 63 – 6410 A fuseIgnition key switchFuse boxBatteryConnect to the vehicle’s reverse lamp harness whenusing the optional rear view camera.Connect to the vehicle’s parkingbrake detection switch harness.• For best safety, be sure toconnect the parking sensor.Depending on what antenna you are using, connect either to the controlterminal of the motor antenna, or to the power terminal for the boosteramplifier of the film-type antenna. (Max. 300 mA, 12 V)When using the optional power amplifier, connect to its power control terminal.Not used.To use the steering wheel remote control feature, an exclusive remote adapter(not supplied) matching your car is required.To car light control switchTo car chassisPurple with white stripe(Reverse sensor wire)Light green (Parkingsensor wire)Connect SiriusXM Connect Vehicle Tuner(commercially available). See page 64.*231White ª / White with black stripe · : To front speaker (left)Gray ª / Gray with black stripe · : To front speaker (right)Green ª / Green with black stripe · : To rear speaker (left)Purple ª / Purple with black stripe · : To rear speaker (right)Blue (Antenna control wire)Blue with white stripe (Power control wire)Brown (Mute control wire)Light blue with yellow stripe (Steering remote control wire)Orange with white stripe (Dimmer control wire)Red (Ignition wire)Yellow (Battery wire)Black (Ground wire)*1 Only for DDX7071BT.*2 Only for DDX8901HD/DDX7701HD/DDX5901HD.*3 If no connections are made, do not let the cable come out from thetab.Connect the antennacord to the antennaterminal.*3Connect to the vehicle’s steering remote harness.Contact your Kenwood dealer for details.*17