Kenwood DNN9250DAB Quick Start Manual

Also see for DNN6250DAB: Instruction manual Instruction manual

24 ñ English• Insulate unconnected wires with vinyl tape or othersimilar material. To prevent a short circuit, do notremove the caps on the ends of the unconnectedwires or the terminals.• Connect the speaker wires correctly to the terminalsto which they correspond. The unit may bedamaged or fail to work if you share the ¤ wires orground them to any metal part in the car.• When only two speakers are being connected tothe system, connect the connectors either to boththe front output terminals or to both the rear outputterminals (do not mix front and rear). For example,if you connect the ¢ connector of the left speakerto a front output terminal, do not connect the ¤connector to a rear output terminal.• After the unit is installed, check whether the brakelamps, blinkers, wipers, etc. on the car are workingproperly.• Mount the unit so that the mounting angle is 30°or less.• This unit has the cooling fan (P.28) to decreasethe internal temperature. Do not mount the unit in aplace where the cooling fan of the unit are blocked.Blocking these openings will inhibit the cooling ofthe internal temperature and result in malfunction.• Do not press hard on the panel surface when installingthe unit to the vehicle. Otherwise scars, damage, orfailure may result.• Reception may drop if there are metal objects nearthe Bluetooth antenna and WI-FI receiver.Bluetooth antenna areaHOME 6DNR8025BT WI-FI receiverN/OUTGPSEXTI/FSW FRONT REARLPOWERFUSE 10APTTM4 x 8mmMAXiPod/AV-IN2REMOTEOUT WiFiRecever5V=500mA• Install the WI-FI receiver besides the place enclosedby the metal.Ñ Supplied accessoriesFirst of all, make sure that all accessories aresupplied with the unit.1 ...1 6 *2 ...1(3.5 m)2 ...1 7 *2 ...13 ...2 8...1(3 m)4 *1...1 9 *3 ...1(3 m)5 ...1 0 *1...1• *1 DNN9250DAB/ DNR8025BT only• * 2 DNN9250DAB/ DNN6250DAB only• *3 DNN9250DAB only