Kenwood DNN9350BT Instruction Manual

Also see for DNN9350BT: Quick start guide Instruction manual

Contents

122Return to the Top pageControlling AudioCrossover network setupYou can set a crossover frequency ofspeakers.1 Touch the speaker to set the crossoverin the Speaker Select screen.2 Touch [X’over].X’over screen appears.3 Set each item as follows.TW (Tweeter) Gain *1Adjust the tweeter level. (When front isselected on Speaker Select screen)GainAdjust the front speaker, rear speaker, orsubwoofer level.Phase *2Set the phase of subwoofer output.The phase is reversed 180 degrees when setto “Reverse”. (When subwoofer is selected onSpeaker Select screen)HPF FREQHigh Pass Filter adjustment. (When front or rearspeaker is selected on Speaker Select screen)LPF FREQLow Pass Filter adjustment. (When subwooferis selected on Speaker Select screen)Slope *3Set a crossover slope.*1 Only when “Tweeter” is set to “Small”,“Middle”, “Large” in .*2 Only when “Subwoofer” is set to a modeother than “None” in .*3 Only when “LPF FREQ”/“HPF FREQ” is set toa mode other than “Through” in .When Speaker network is set to 3 way:Region code 3 areaRange switching area (graph)Selects the band for setting gain, frequencyfilter, and slope.Touch the left arc to set the LPF, the center arcto set the BPF, and the right arc to set the HPF.PhaseSets the phase of tweeter, mid range, andwoofer output.The phase is reversed 180 degrees when set to“Reverse”.GainSets gain of each speaker.HPF FREQHigh Pass Filter adjustment. (When tweeter isselected on Speaker Select screen)BPF FREQBand Pass Filter adjustment. (When mid rangespeaker is selected on Speaker Select screen)LPF FREQLow Pass Filter adjustment. (When woofer isselected on Speaker Select screen)SlopeSets a crossover slope.NOTE• For how to switch to the 3-way speaker system,see 3 way speaker system setup (P.26)in the Quick Start Guide. Connecting 3-wayspeakers with the 2-way mode selected can breakthe speakers.