2 DNX SERIESInstallation ProcedureAccessories1. To prevent short circuits, remove the keyfrom the ignition and disconnect the -terminal of the battery.2. Make the proper input and output wireconnections for each unit.3. Connect the wire on the wiring harness.4. Take Connector B on the wiring harnessand connect it to the speaker connector inyour vehicle.5. Take Connector A on the wiring harnessand connect it to the external powerconnector on your vehicle.6. Connect the wiring harness connector tothe unit.7. Install the unit in your car.8. Reconnect the - terminal of the battery.9. Press the reset button.10. Perform the Initial Setup. (Refer to theInstruction Manual.)2WARNING• If you connect the ignition wire (red) and thebattery wire (yellow) to the car chassis (ground),you may cause a short circuit, that in turn maystart a fire. Always connect those wires to thepower source running through the fuse box.• Do not cut out the fuse from the ignition wire(red) and the battery wire (yellow). The powersupply must be connected to the wires via thefuse.Acquiring GPS SignalsThe first time you turn on this unit, youmust wait while the system acquires satellitesignals for the first time. This process couldtake up to several minutes. Make sure yourvehicle is outdoors in an open area away fromtall buildings and trees for fastest acquisition.After the system acquires satellites for thefirst time, it will acquire satellites quickly eachtime thereafter.About the Front PanelWhen removing the product from thebox or installing it, the front panel may bepositioned at the angle shown in (Fig. 1). This1..........12..........13..........14..........15..........26..........17..........18..........19..........10..........1