Kenwood DNX7280BT Instruction Manual

Also see for DNX4280BT: Quick start guide Instruction manual Service manual

Contents

79Return to the Top pageAudio Setting Up2 Select a speaker size using [2] and[3]. The speaker size is differentdepending on the speaker type andthe unit.FrontOEM, 10 cm, 13 cm, 16 cm, 17 cm, 18 cm, 4x6,5x7, 6x8, 6x9, 7x10RearNone, OEM, 10 cm, 13 cm, 16 cm, 17 cm, 18cm, 4x6, 5x7, 6x8, 6x9, 7x10SubwooferNone, 16 cm, 20 cm, 25 cm, 30 cm, 38 cm overNOTE• Select “None” if you have no speakers.Front/Rear/SubwooferStandard, Wide, Middle, NarrowCrossover network setupYou can set a crossover frequency ofspeakers.1 Touch the speaker to set the crossoverin the Speaker Select screen.2 Touch [X’over].X’over screen appears.3 Set each item as follows.Phase*Sets the phase of subwoofer output.The phase is reversed 180 degrees when set to“Reverse.”HPF FREQHigh Pass Filter adjustment. (When front or rearspeaker is selected on Speaker Select screen)LPF FREQLow Pass Filter adjustment. (When subwooferis selected on Speaker Select screen)SlopeSets a crossover slope.* This function is available in the specificsituation.Only when “Subwoofer” is set to“ON” in “Speaker Setup”.Only when “Subwoofer” isset to “ON” in “Speaker Setup” and “LPFFREQ” is set to other than “Through”.Car type (DTA) setupYou can setup the car type and speakernetwork, etc.1 Touch [Car Type] in the Audio SETUPscreen.Car Type screen appears.2 Select your car type from the list.NOTE• You may not be able to select your car type fromthe list.• If your car type is selected, the Delay TimeAlignment and Equalizer is set automatically (fortiming adjustment of sound output for eachchannel) to have the highest surround effects.