Kenwood DPX-MP7090U Instruction Manual

Also see for DPX-MP7090U: Service manual

English | 112 Select the Sound typePress the [Q] button.When you press the button once, the currentsound setting is displayed.Each time you press the button, the soundsetting alternates.Sound setting DisplayUser memory "USER"Rock "ROCK"Pops "POPS"Easy "EASY"Top 40 "TOP 40"Jazz "JAZZ"Natural "NATURAL"• User memory: The values set on the

(page 11).• Change each setting value with the Setting> (page 13).First, select the speaker type with the Speaker setting.Audio Control1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [VOL] knob.3 Select the Basic Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Basic Audio itemTurn the [VOL] knob.Adjustment Item Display RangeRear Volume * 1 "Rear Volume" 0 — 35Subwoofer level*2,3 "Sub-W Level" –15 — +15Bass level*4 "Bass Level" –8 — +8Middle level* 4 "Middle Level" –8 — +8Treble level*4 "Treble Level" –8 — +8Balance "Balance" Left 15 — Right 15Fader*3 "Fader" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)• *1 You can control this item when "2 ZONE" of Setup> (page 12) is set to "ON".• * 2 You can control this item when Output> (page 13) is set to "SW ON".• *3 You can control this item when "2 ZONE" of Setup> (page 12) is set to "OFF".• *4 You can adjust these items in detail. Refer to(Page12).• * 4 Source tone memory: Puts the set up value in thememory per source. (Detail Audio item is included)5 Exit Audio Control modePress any button.Press a button other than the [VOL] knob and[ATT] button.System QSelecting the best sound setting preset fordifferent types of music.1 Select the source to setPress the [SRC] button.