Kenwood DPX-MP7090U Instruction Manual

Also see for DPX-MP7090U: Service manual

English | 135 Exit Audio Setup modePress the [VOL] knob for at least 1 second.Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Speaker Setting modePress the [VOL] knob."SP SEL" is displayed.3 Select the Speaker typeTurn the [VOL] knob.Each time you turn the knob, the settingalternates between the settings shown in thetable below.Speaker type DisplayOFF "OFF"For 5 & 4 in. speaker "5/4 inch"For 6 & 6x9 in. speaker "6x9/6 inch"For the OEM speaker "O.E.M."4 Exit Speaker Setting modePress the [VOL] knob.Subwoofer OutputTurning the Subwoofer output ON or OFF.Push the Control knob toward [AM] for atleast 2 seconds.Each time you push the knob, Subwoofer outputswitches ON and OFF.When it is ON, "SW ON" is displayed.• You can control this function when "2 ZONE" of

TEL MuteThe audio system automatically mutes when acall comes in.When a call comes in"CALL" is displayed.The audio system pauses.Listening to the audio during a callPress the [SRC] button.The "CALL" display disappears and the audiosystem comes back ON.When the call endsHang up the phone.The "CALL" display disappears and the audiosystem comes back ON.• To use the TEL Mute feature, you need to hook upthe MUTE wire to your telephone using a commercialtelephone accessory. Refer to Terminals> (page 38).