Kenwood KDC-232MR Instruction Manual

Also see for KDC-232MR: Training guide Instruction manual Instruction manual Service manual

Kenwood KDC-232MR Instruction Manual Manual pdf 30 page image

30 | EnglishRemoving the UnitRemoving the hard rubber frame1 Engage the catch pins on the removal tool andremove the two locks on the upper level.Upper the frame and pull it forward as shown inthe figure.2 When the upper level is removed, remove thelower two locations.• The frame can be removed from the bottom side in thesame manner.Removing the Unit1 Refer to the section frame> (page 30) and then remove the hardrubber frame.2 Remove the screw (M4 × 8) on the back panel.3 Insert the two removal tools deeply into the slotson each side, as shown.4 Lower the removal tool toward the bottom, andpull out the unit halfway while pressing towardsthe inside.• Be careful to avoid injury from the catch pins on theremoval tool.5 Pull the unit all the way out with your hands,being careful not to drop it.CatchLockAccessory2Removal toolAccessory2Removal toolScrew (M4X8)(commercially available)