Kenwood KDC-232MR Instruction Manual

Also see for KDC-232MR: Training guide Instruction manual Instruction manual Service manual

Kenwood KDC-232MR Instruction Manual Manual pdf 9 page image

English | 9Audio Control1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [VOL] knob.3 Select the Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeBass level "BAS L" –8 — +8Middle level "MID L" –8 — +8Treble level "TRE L" –8 — +8Balance "BAL" Left 15 — Right 15Fader "FAD" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)5 Exit Audio Control modePress any button.Press a button other than the [VOL] knob, [SRC],[0] and [ATT] button.Audio SetupSetting the Sound system, such as Volume offsetand Loudness.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Setup modePress the [VOL] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Audio setup itemTurn the [VOL] knob.Adjustment Item Display RangeVolume offset "V-OFF" –8 — ±0Loudness "LOUD" ON/OFF• Volume offset: Sets each source’s volume as adifference from the basic volume.• Loudness: Compensates for low and high tonesduring low volume.When Loudness is ON, "LOUD" indicatoris ON.5 Exit Audio Setup modePress the [VOL] knob for at least 1 second.2 Select the Sound typePress the [Q] button.When you press the button once, the currentsound setting is displayed.Each time you press the button, the soundsetting alternates.Sound setting DisplayNatural "NATURAL"Rock "ROCK"Pops "POPS"Easy "EASY"Top 40 "TOP40"Jazz "JAZZ"• Change each setting value with the Setting> (page 10).First, select the speaker type with the Speaker setting.• When the value is set up by

"USER" is displayed.