Kenwood KDC-6090R Instruction Manual

Kenwood KDC-6090R Instruction Manual Manual pdf 28 page image

After a security code has been registered, power cannot berestored if the battery is disconnected from the unit unless thecode is first input.All the steps in this procedure (1 through 7) must be completedbefore the code security function can be turned on. However,once the procedure is finished, it need not be repeated.Once the code security function has been activated, "Security"disappears from the MENU system. Note that it will no longer bepossible to cancell this function afterwards.Press the SRC button repeatedly to select the standby mode."ALL OFF" is displayed when the standby mode is selected.Hold down the MENU button for one second or more."MENU" is displayed first and then "Security" is displayed.Hold down either the 4 or ¢ button for one second ormore."ENTER" will appear in the display for one second, indicatingthe code setting mode has been entered. When "CODE"appears in the display, you can start inputting the code.Press the preset button and enter your security code.Use the security code shown on your Car Audio Passport.Example: Enter "3510" as your code, pressing the buttons asfollows:Hold down the DISP button for three seconds or more.The security code will be set."RE-ENTER" will appear in the display for one second, askingyou to enter the code once again for confirmation. When5Step Button to press # Timespressed Display1 #1 436#22#3 24 #4 1“3”“5”“1”“0”4321NOTECode Security FunctionYou can set the defaults for additional functions in the menumode. Make a setting for each function, referring to thefollowing operations.Enter the menu modeHold down the MENU button for one second or more."MENU" is displayed when the menu mode is entered.The function that you can adjust is indicated with the currentsettings displayed.Selecting function to setPress the FM button to search through the functions until yousee the one you want to adjust in the display.Press the AM button to search through the functionsbackward.Function items change in the order of features that follow inthe menu system.Example: If you want to switch the setting of the touch sensortone function from on to off, first search through thefunctions until you see "Beep ON" in the display.Changing setting for currently displayed functionPress either the 4 or ¢ button.The setting will change for each function.Example: The setting of the touch sensor tone will switch fromon to off, and "Beep OFF" is displayed.Ending the menu modePress the MENU button.Make sure to end the menu mode when finished.If you fail to end the menu mode, several functions may notoperate properly, including the Traffic Information function, theNews Bulletin function with PTY news timeout setting, and theAlarm function.NOTE4321Menu SystemMenu settings— 28 —English