| 
English | 37PROTECT (Blink):The speaker wire has a short-circuit ortouches the chassis of the vehicle, and thenthe protection function is activated.➪ Wire or insulate the speaker cableproperly and press the reset button. Ifthe “PROTECT” code does not disappear,consult your nearest service center.NA FILE: An Audio file is played with a format that thisunit can’t support.COPY PRO: A copy-protected file is played.READ ERROR: The file system of the connected USB deviceis broken.➪ Copy the files and folders for the USBdevice again. If the error message is stilldisplayed, initialize the USB device or useother USB devices.NO DEVICE: The USB device is selected as a sourcealthough no USB device is connected.➪ Change the source to any source otherthan USB. Connect an USB device, andchange the source to USB again.N/A DEVICE: • An unsupported USB device is connected.• Connection to the iPod has failed.➪ Check that the connected iPod is an iPodthat is supported. See (page 30) for information on supportediPods.NO MUSIC DATA/ERROR 15:• The connected USB device contains noplayable audio file.• Media was played that does not have datarecorded that the unit can play.USB ERROR: Some trouble may have occurred to theconnected USB device.➪ Remove the USB device, then cycle thepower switch to ON. If the same display isrepeated, use another USB device.iPod ERROR: Connection to the iPod has failed.➪ Remove the USB device and thenreconnect it.➪ Confirm that the software for the iPod isthe latest version.USB REMOVE (Blink):The Remove mode has been selected for theUSB device/iPod. You can remove the USBdevice/iPod safely.NO NUMBER: • The calling party does not notify a caller ID.• There is no phone number data.NO DATA: • There is no outgoing call list.• There is no incoming call list.• There is no missed call list.• There is no phone book list.NO ENTRY: The cell-phone has not been registered(pairing).HF DISCONCT: The unit cannot communicate with the cell-phone.HF ERROR 07: The memory cannot be accessed.➪ Turn off the power and on again. If thismessage still appears, press the resetbutton on the control unit.HF ERROR 68: The unit cannot communicate with the cell-phone.➪ Turn off the power and on again. If thismessage still appears, press the resetbutton on the control unit.UNKNOWN: The Bluetooth device cannot be detected.DEVICE FULL: 5 Bluetooth device have already beenregistered. No more Bluetooth device cannotbe registered.PIN CODE NG: The PIN code is wrong.CONNECT NG: The unit cannot be connected to the device.PAIRING NG: Pairing error.NO MATCHING: The voice tag is wrong. Voice cannot berecognized because of an unregistered voicetag, etc.TOO SOFT: Voice is too small and cannot be recognized.TOO LOUD: Voice is too large to be recognized.TOO LONG: The word or utterance is too long to berecognized.NO PHONEBOOK:Data is not contained in the phone book.NO MESSAGE: No short message in In Box.NO RECORD: The voice tag is not registered in thephonebook.MEMORY FULL: The number of voice tags reaches themaximum number to be registered in thephonebook.FAV: NO MEMORY :The procedure is not registered to FavoritePreset MemoryNO ACCESS : The procedure preset with Favorite Controlcannot be available. The preset content maynot be recalled depending on the selectedsource or mode.NO VOICE : No call.NO PANEL : The faceplate of the slave unit beingconnected to this unit has been removed. |
