Kenwood KDC-BT8044U Instruction Manual

Contents

Kenwood KDC-BT8044U Instruction Manual Manual pdf 50 page image

Accessory of KDC-BT8044U/ KDC-BT8044UYInstallation the Microphone Unit1 Check the installation position of the microphone(accessory 3).2 Remove oil and other dirt from the installationsurface.3 Install the microphone.4 Wire the microphone cable up to the hands-freebox with it secured at several positions using tapeor the like.Fix a cable with a commercialitem of tape.Peel the release coated paper of double-face adhesive tape tofix on the place shown above.Adjust the direction of the microphone to the driver.Accessory3⁄• Install the microphone as far as possible from the cell-phone.50 | KDC-BT8044U/ KDC-BT8044UY/ KDC-W7544U/ KDC-W7644UY/ KDC-W7044U/ KDC-W7144UYRemoving the hard rubber frame1 Engage the catch pins on the removal tool andremove the two locks on the upper level.Upper the frame and pull it forward as shown inthe figure.CatchLockAccessory2Removal tool2 When the upper level is removed, remove thelower two locations.⁄• The frame can be removed from the bottom side in thesame manner.Removing the Unit1 Refer to the section frame> and then remove the hard rubber frame.2 Insert the two removal tools deeply into the slotson each side, as shown.3 Lower the removal tool toward the bottom, andpull out the unit halfway while pressing towardsthe inside.Accessory2¤• Be careful to avoid injury from the catch pins on theremoval tool.4 Pull the unit all the way out with your hands, beingcareful not to drop it.Installation/Removing the Unit