— 28 —EnglishOther features (See page 8)Audio Control SettingAdjust various parameters of sound quality.Press the AUD button to enter the control mode.Press either the FM or AM button.Each time the button is pressed, the adjustment mode willchange as follows:Pressing the FM button advances the display, and pressing theAM button reverses it.tBass High-pass filter (rear)t sTreble High-pass filter (front)t sBalance N-F Level (only when being switched)t sFaderSource tone memoryEach source (CD, FM, AM, and disc changer) has its ownmemory in which to store the bass and treble tone settings.The settings made for a particular source are then recalledautomatically whenever you use that source (e.g., FM mode usesthe tone settings made for FM, AM for AM, etc.).Press the 4/¢ button.Look at the table to adjust the mode being displayed.Press the AUD button to end the control mode.Setting the high-pass filterYou can separately set the high-pass filter for front and rearoutput, including preouts. The high-pass filter works exceptduring non- fading preout when switching to non-fading.The factory default settings for front output and rear output are"through".NOTE43NOTE21Table of Audio Control SettingBass(“BAS”)Treble(“TRE”)Balance(“BAL”)Fader(“FAD”)Non-FadingPreout Level(“NF”)Bass decreased.Treble decreased.Left channelemphasized.Rear channelincreased.The front and rearsound is emphasized.Bass increased.Treble increased.Front channelincreased.The non-fading sound isemphasized.Right channelemphasized.Adjustmentmode(Display) 4 button ¢ buttonOperation of Audio control buttonHigh-passfilter for frontoutput(“HPF F”)You can select the frequency to be cut, asfollows:THROU (through) Ö 40Hz Ö 60Hz Ö 80Hz Ö100Hz Ö 120Hz Ö 150Hz Ö 180Hz Ö 220HzHigh-passfilter for rearoutput(“HPF R”)You can select the frequency to be cut, asfollows:THROU (through) Ö 40Hz Ö 60Hz Ö 80Hz Ö100Hz Ö 120Hz Ö 150Hz Ö 180Hz Ö 220HzKDC-PS9060R only(KDC-PS9060R only)(KDC-PS9060R only)