10 | EnglishGeneral featuresSystem QYou can recall the best sound setting preset fordifferent types of music.1 Select the source to setPress the [SRC] button.2 Select the Sound typePress the [Q] button.Each time the button is pressed the soundsetting switches.Sound setting DisplayFlat "Flat"User memory "User"Rock "Rock"Pops "Pops"Easy "Easy"Top 40 "Top40"Jazz "Jazz"• User memory: The values set on the 'Audio Control'(page 10).• Each setting value is changed with the 'SpeakerSetting' (page 10).First, select the speaker type with the Speaker setting.Audio Control1 Select the source for adjustmentPress the [SRC] button.2 Enter Audio Control modePress the [AUD] button for at least 1 second.3 Select the Audio item for adjustmentPress the [FM] or [AM] button.Each time the button is pressed the items thatcan be adjusted switch as shown below.4 Adjust the Audio itemPress the [4] or [¢] button.Adjustment Item Display RangeBass level "Bass" –8 — +8Middle level "Middle" –8 — +8Treble level "Treble" –8 — +8Balance "Balance" Left 15 — Right 15Fader "Fader" Rear 15 — Front 15Sub woofer level* "SW Level" –15 — +15Front/Rear High PassFilter"HPF" THRU/100/125/170 HzSub woofer Low PassFilter*"LPF SW" 50/80/120/THRU HzVolume offset "V-offset" –8 — ±0Loudness "LOUD" ON/OFF• Volume offset: Each source’s volume can be set as adifference from the basic volume.• Loudness: Compensating for low and high tonesduring low volume.• * You can control this item when 'Switching preout'(page 25) is set to 'SWPRE Sub-W'.5 Exit Audio Control modePress the [AUD] button.Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Speaker Setting modePress the [Q] button.3 Select the Speaker typePress the [4] or [¢] button.Each time the button is pressed the settingswitches as shown below.Speaker type DisplayOFF "SP OFF"For 5 & 4 in. speaker "SP 5/4inch"For 6 & 6x9 in. speaker "SP 6*9/6inch"For the OEM speaker "SP O.E.M."4 Exit Speaker Setting modePress the [Q] button.