Kenwood KDC-W6537U Instruction Manual

Also see for KDC-W6537U: Firmware update guide Service manual

Kenwood KDC-W6537U Instruction Manual Manual pdf 33 page image

English | 33Connecting Wires to TerminalsMUTEP.CONTANT.CONT1234567812345678REMO.CONTAUX INBattery wire (Yellow)Ignition wire (Red)FM/AM antenna inputAntenna Cord (ISO)Antenna Conversion Adaptor (ISO–JASO)(Accessory3)To connect the Kenwood navigation system, consultyour navigation manual.Wiring harness(Accessory1)If no connections are made, do notlet the wire come out from the tab.Power control/Motor antennacontrol wire (Blue/White)TEL mute wire (Brown)Connect either to the power control terminalwhen using the optional power amplifier, or to theantenna control terminal in the vehicle.Connect to the terminal that is grounded wheneither the telephone rings or during conversation.A–7 Pin (Red)A–4 Pin (Yellow)Connector AConnector BSee next pageSteering remote control (Light Blue/Yellow) (KDC-W6537U only)To Kenwood disc changer/External optional accessoryTo connect these leads, refer to the relevantinstruction manuals.Rear left output /Sub Woofer left output (White)Rear right output /Sub Woofer right output (Red)Do not remove the cap when you do not use the USBcable. The connector will cause the unit to malfunctionif it gets in touch with any metallic part of the vehicle.USB connector (1m)To USB deviceFuse (10A)Front left output (White)Front right output (Red)AUX input (Stereo)Use the mini-plug which is stereo typeand does not have any resistance.