Kenwood KDC-W6537U Instruction Manual

Also see for KDC-W6537U: Firmware update guide Service manual

Kenwood KDC-W6537U Instruction Manual Manual pdf 8 page image

8 | EnglishGeneral featuresAttenuatorTurning the volume down quickly.Press the [ATT] button.Each time you press the button, the Attenuatorturns ON and OFF.When the Attenuator is ON, the "ATT" indicatorblinks.Audio Control1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [VOL] knob.3 Select the Basic Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Basic Audio itemTurn the [VOL] knob.Adjustment Item Display RangeSubwoofer level "SW L" –15 — +15System Q "USER"/"ROCK"/"POPS"/"EASY"/"TOP40"/"JAZZ"/"NATURAL"User/Rock/Pops/Easy/Top 40/Jazz/NaturalBass level* "BAS L" –8 — +8Middle level* "MID L" –8 — +8Treble level* "TRE L" –8 — +8Balance "BAL" Left 15 — Right 15Fader "FAD" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)* Source tone memory: Puts the set up value in thememory per source.⁄ About System Q• You can recall the best preset sound setting for differenttypes of music.• Change each setting value with the (page 9). First, select the speaker type with the Speakersetting.• "USER": The ranges selected lastly for Bass level, Middlelevel, and Treble level are recalled automatically.5 Exit Audio Control modePress any button.Press a button other than the [VOL] knob and [ATT]button.Audio SetupSetting the Sound system, such as Cross overNetwork.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Setup modePress the [VOL] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Setup the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeFront High Pass Filter "HPF" Through/40/60/80/100/120/150/180/220 HzRear High Pass Filter "HPR" Through/40/60/80/100/120/150/180/220 HzLow Pass Filter "LPF" 50/60/80/100/120/Through HzSubwoofer Phase "PHAS" Reverse (180°)/ Normal (0°)Volume offset "V-OFF" –8 — ±0 (AUX: -8— +8)Loudness "LOUD" OFF/ON⁄• Volume offset: Sets each source’s volume as a differencefrom the basic volume.• Loudness: Compensates for low and high tonesduring low volume. (Only the low tone iscompensated for when the tuner is selectedas a source.)5 Exit Audio Setup modePress the [VOL] knob for at least 1 second.